Service: normalStatusRoute plannerETEN

Tram line T2 — Kopli – Vanasadam – Lennujaam

The only line through Vanasadam — and, from 1 August 2026, straight to the airport.

Updated: November 2026
26
stops
~40 min
end to end
10 min
interval at peak times
Kopli ↔ Lennujaam
termini

Tram line T2: Kopli – Vanasadam – Lennujaam

Line T2 is the newest route on Tallinn’s tram network and the only one that runs through Vanasadam. The Vanasadam tramway opened at the end of 2024 and brought the tram right up to the passenger port terminals.

From 1 August 2026, T2 continues from Majaka põik on to Ülemiste linnak and the airport (it does not stop at Ülemiste station). That means you can now go from ferry to plane — from the Helsinki boat to Lennart Meri Tallinn Airport — on a single tram, without a single change. The journey from Vanasadam to the airport takes about 18–20 minutes.

The whole route from Kopli to the airport is 26 stops and about 40 minutes. On weekdays the tram departs every 10–11 minutes at peak times and every 13 minutes around midday.

From 1 August 2026: tram line numbers gain a T prefix (1 → T1, 2 → T2, and so on) and the tram runs to the airport again. The old numbers may linger for a while on stops and older maps — the routes themselves stay the same, except for the southern end of T2 and T4.
Tallinna trammiliini T1 tramm marsruudil Kopli – Kadriorg
Tallinn tram on line T2 · photo Wikimedia Commons

Line T2 stops

Stops in the main direction Kopli → Lennujaam. Times are cumulative from the terminus and are based on the TLT timetable.

Tram line T2 · Kopli – Vanasadam – Lennujaam

line T2 — Journey times between stops

StopNextJourney timeTotal
Kopli→Sepa1 min1 min
Sepa→Marati1 min2 min
Marati→Sirbi2 min4 min
Sirbi→Maleva1 min5 min
Maleva→Sitsi2 min7 min
Sitsi→Angerja1 min8 min
Angerja→Krulli2 min10 min
Krulli→Volta1 min11 min
Volta→Salme1 min12 min
Salme→Telliskivi1 min13 min
Telliskivi→Balti jaam2 min15 min
Balti jaam→Põhja puiestee1 min16 min
Põhja puiestee→Suur Rannavärav2 min18 min
Suur Rannavärav→Linnahall2 min20 min
Linnahall→Vanasadam1 min21 min
Vanasadam→Laeva2 min23 min
Laeva→A. Laikmaa4 min27 min
A. Laikmaa→Paberi3 min30 min
Paberi→Keskturg1 min31 min
Keskturg→Bussijaam3 min34 min
Bussijaam→Majaka3 min37 min
Majaka→Sikupilli1 min38 min
Sikupilli→Majaka põik1 min39 min
Majaka põik→Ülemiste linnak4 min43 min
Ülemiste linnak→Lennujaam2 min45 min

Line T2 timetable

First departure (Mon–Fri)05:00
Last departure (Mon–Fri)00:35
First departure (Sat–Sun)05:20
Last departure (Sat–Sun)00:35
Interval at peak times10 min
Interval during the day13 min
Interval in the evening15 min
Interval at weekends15 min
Journey time end to end~40 min
Please note: tallinntram.com is an independent information site and is not affiliated with the City of Tallinn or Tallinna Linnatranspordi AS. Fares, times and service arrangements can change — check the official information at transport.tallinn.ee before you travel.

History of line T2

2017
The airport branch opens — the tram reaches Tallinn Airport for the first time.
2023
The airport connection closes for construction of the Vanasadam tramway and the Ülemiste terminal.
2024
The Vanasadam tram line opens; line 2 is rerouted via Linnahall and the port.
2026
Line 2 becomes T2 and the line is extended to the airport instead of Suur-Paala.

line T2 — What to know about this line

Good to know

Two different ways through the city centre

From Suur Rannavärav, T2 runs via Linnahall and Vanasadam, while the other Kopli lines go via Kanuti and Mere puiestee. If the port is your destination, you need to board T2 specifically.

Good to know

Luggage and suitcases

There is no separate luggage compartment on the tram, but the low-floor CAF Urbos and Pesa Twist cars are spacious and easy to board with a suitcase.

line T2 — Changes to other lines

T1Kopli – Kadriorg
14 shared stops: Kopli · Sepa · Marati · Sirbi · Maleva · Sitsi · Angerja · Krulli +6
T4Tondi – Lennujaam
T5Kopli – Vana-Lõuna
14 shared stops: Kopli · Sepa · Marati · Sirbi · Maleva · Sitsi · Angerja · Krulli +6
T6Kopli – Hobujaama – Suur-Paala
20 shared stops: Kopli · Sepa · Marati · Sirbi · Maleva · Sitsi · Angerja · Krulli +12

Frequently asked questions about line T2

Yes — from 1 August 2026 T2 runs from Kopli through Vanasadam straight to Tallinn Airport.

Board line T2 by the Vanasadam terminals and ride to the end. The journey takes about 18–20 minutes and the ticket costs the price of a standard hourly ticket.

On weekdays every 10–11 minutes at peak times, every 13 minutes around midday and every 15 minutes in the evening; at weekends every 15 minutes during the day.

Before 1 August 2026, line 2 ran from Kopli via Vanasadam to Suur-Paala. The Suur-Paala connection is now maintained by the new line T6.

🔖

Add this site to your favourites

We review Tallinn Tram regularly and update it when the operator changes timetables or fares or publishes an important notice. Save the page and check it before you travel.

On this page